Innovative 170W LED indoor high bay with radar sensor, very low glare and excellent efficiency. The LED indoor high bay with radar sensor detects movements when entering the detection area and switches the indoor spotlight on to 100% brightness. As long as the radar sensor detects movements, it remains fully switched on.
If no movements are detected, a delay time of up to 10 minutes can be set. Afterwards, the lamp can be switched to a dimmed state in order to achieve a standard brightness.
This saves additional energy in daily use in areas that are only entered irregularly, since the hall spotlight does not have to be permanently illuminated. There are a number of adjustment options. The hall spotlight can be mounted up to a height of 12m.
The detection range of the LED indoor spotlight depends on the mounting height and is calculated from the center position of the spotlight on the floor. A good position is from approx. 4 meter mounting height (5.3 meter detection radius) up to 12m mounting height (1.2m detection radius). A very good mounting height is between 5m and 7m. The detection radius there is 5.5m-6m.
60° low beam high bay| 170W | UGR<14 | 5,000K daylight white | CRI 82 | IP65 | 22390 lumen | 80° high bay light 170W | UGR<18 | 5,000K daylight white | CRI 82 | IP65 | 22390 Lumen | 110° high bay 170W | UGR<24| 5.000K daylight white | CRI 82 | IP65 | 22390 Lumen |
- Brightness with motion detection: 30 seconds | 60 sec. 300 sec. 600 sec.
- Dimming brightness without motion detection: 10% | 20% | 30% | 50%
- Delay time dimmed: 0 sec. 30 sec. 120 sec. 300 sec.
- Switch off sensor: Yes | No
Great importance was attached to the low glare of the hall spotlights in the development of the LED hall lighting. Compared to other well-known manufacturers, the glare value is significantly lower than that of other models. The low glare value of UGR<18 (80°) or UGR<26 (110°) ensures that no disturbing glare is created when looking directly into the LED hall luminaire. This must be avoided when using forklift trucks or if direct eye contact has a negative effect on the quality of work and work safety due to glare.
We also offer this model as a pure LED High Bay light without sensor as a 60° LED narrow beam and wide beam LED High Bay with 80° or 110°.
The LED indoor spotlight is equipped with 576 SAMSUNG SMD quality LEDs. The individual LEDs are only supplied with partial load. This improves the cooling of the individual LEDs and has a positive effect on their durability and service life. The IP65 Meanwell power supply units used are also absolute quality components that are considered extremely durable in operation.
This LED hall lighting replaces an old 400W -500W HQL spotlight without any problems. We offer this LED hall lighting in a pleasant 5000K color tone. This model is also in comparison to many LED indoor spotlights available on the market by approx. 20% more efficient. The manufacturer grants 5 years warranty. At the end of its service life, the model still achieves 80% of the specified luminous flux.
Manufacturer: Interlight Manufacturer: ILCLHB155K56R (60°) /ILCLHB155K58R (80°) / ILCLHB155K511R (110°) | Voltage 230V / 50 Hz | Light colour: 5000 K (daylight) | Luminous flux: 23300lm± 5% | Life span: 50,000 hours Efficiency: 137Lm/Watt | with radar sensor / motion detector | LED type: SAMSUNG 576 pieces | Power consumption: 170Watt | Power factor: cos phi > 0.97 | Driver Meanwell Efficiency: > 90% | CRI 82 | Application temperature: -30°C to +50°C | Dimensions: Diameter 400mm / Height: 133mm / Height with ceiling hook: 150mm | Impact resistance
Do you have any special questions about our LED indoor spotlights in the different versions and their special application? As technical energy manager TÜV Süd, efficiency is our business. We will be happy to advise you! Preferably personally! You can reach us under the telephone number: 0221-29821660 during our business hours or by mobile phone. You can also contact us via e-mail form or fax inquiry. We will also gladly call you back.
